Tools Needed:
- soldering iron ( here’s a helpful tutorial on soldering )
- electronic solder
- diagonal cutter
- Mini glue gun
Components for the robot
- 2x – small DC motors
- 2x – small paperclips
- 2x – big paperclips
- 2x – batteries AAA or AA
- 1x – AA battery holder or AAA battery holder
- 1x – 2 cm of heat shrink
- 1x – wooden pearl (for the caster)
- 1x – meter of electric wire
- 2x – Sub-mini lever SPDT switches
Most of the components can be bought for find much cheaper at hone and office , you can find the dual AA battery holder and the small DC motor. You can also find these components at any good electronic component store. Here are all the parts needed for the construction the beetle robot: we Used Old Printers and some Non- Usable Electronic Equipment Parts.
1. Cut the electric wire in pieces of 6 cm each, 13 times.
Strip 1 cm at each end.
2. Regroup all the components.
3. Solder each wire to each components except the two batteries.
4. Take the battery holder and make a connection to the connection.
This will give a third connection.See picture below
The blue wire is the third connections
5. Turn the battery holder up side down so the batteries point to the ground. Glue the two switches on the battery holder in a V form.
6. Glue the motor beside each switch so that the shaft touches the ground
7. Take the big paperclip and make the caster like the picture below.
You can make a nice looking caster or a normal one
9. Take the small paper clip and bend them to make antenna.
Add 1 cm of heat shrink to the shaft of each motor.
